Letus Helix Jr. Handheld Gimbal Stabilizer with Encoded Motors

About Letus Helix Jr. Original Design Designed from the ground up specifically for cinematography, not after thought like the rest of the gimbals on the market which put a handle onto the copter gimbal system. Optically-centered To minimize sensor movement avoid robotic look in footage found with other gimbals. Eye-level Filming Your hands is at the lens level, not a foot higher like other gimbals. This make shooting a lot fatigue. Quick Balancing It’s a lot easier to balance each axis individually than making all 3 axis balance at the same time. Lens change is easier with simple adjustment of a single axis due to optical center design. Flat-bottom Design You can put the gimbal down between shots without needing a stand. Intuitive Tilt Handle The right handle of the gimbal acts as a joystick for tilting the camera up and down. This is the best loved feature. Seamless Suitcase Mode Transition Going from eye-level to low mode seamlessly by just letting go of the left handle. Absolute Encoders Prevent motors from losing their position during a bump. Improve stabilization precision. Adjust Dutch angle within a second by holding at the desired angle. Note: Helix Jr. is wired according to US standards where red pin is Positive (+). Any 3rd-party power accessories must be compatible. Letus Helix Jr. Features Custom Firmware 3-Axis stabilization with encoded motors WiFi and Bluetooth installed RC 2nd Operator Mode (optional) Payload up to 8lbs (up to 12lbs if the the setup is less than 8″ long) Made In USA COMPATIBILITY Designed for use with: Panasonic GH3 and GH4